![background image](http://html.mh-extra.com/html/karcher/km-105-100-r-d/km-105-100-r-d_manual_655718044.webp)
-
17
Note:
The side brush floating mounting ad-
justs the sweeping track as the bristles
wear down. The side brush must be re-
placed if it becomes too worn.
Recommendation
: Replacing the side
brush at a remaining bristle length of ap-
prox. 10 cm.
Park the machine on an even surface.
Turn the programme selector switch to
"OFF" and remove the KIK-key.
Note
: The side brush is raised.
Unscrew all 3 star grip nuts at the bot-
tom of the side brush by hand. For this
purpose reach through the bristles of
the side brush.
Remove the wiper blade.
Clip new side brushes on to driver and
screw on.
Park the sweeper on an even surface.
Activate parking brake.
With appliance with low emptying
system:
Turn the programme selector switch to
"OFF" and remove the KIK-key.
Remove both waste containers.
Remove belts or cords from roller
brush.
With appliance with high emptying
system:
Turn the programme selector switch to
"ON".
Lift the waste container and secure by
means of cylinder support.
Remove belts or cords from roller
brush.
The sweeping track of the roller brush is au-
tomatically adjusted by a system called
TEACH.
The condition of the roller brush can be
shown on the display.
Turn the programme selector switch to
"ON".
Push the direction key "upwards" or
"downwards" until the display >
usabil-
ity of the roller brush: ..%
< appears.
Note:
If the roller brush is heavily worn, the
indication >
Usability of the roller brush
<25%
< appears on the display.
Now, at the latest, the roller brush should
be replaced.
The replacement is required if the sweep-
ing result visibly decreases due to the wear
of the bristles or the indication >
Usability
of the roller brush <25%
< appears on the
display.
Each roller brush half is attached to the
shaft by means of 2 screws. Both halves
are identical, which facilitates the installa-
tion.
Park the machine on an even surface.
Activate parking brake.
With appliance with low emptying
system:
Turn the programme selector switch to
"OFF" and remove the KIK-key.
Remove both waste containers.
Note
: For the removal of the roller
brush dismount the centre bar first.
Loosen the screw and remove the cen-
tre bar.
The next steps for removing the roller
brush are described in the following
Chapter "With devices with high empty-
ing system".
With appliance with high emptying
system:
Turn the programme selector switch to
position C (drive).
Lift the waste container and secure by
means of cylinder support.
Turn the programme selector switch to
"OFF" and remove the KIK-key.
1 Screws
2 Roller brush
Unscrew both screws by hand and pull
the roller brush half from the shaft.
Insert new roller brush halves and tight-
en the screws (pay attention to the
marking "L" = left and "R" = right).
Turn the roller brush by 180 °, loosen
and remove the screws from the sec-
ond roller brush half.
Insert new roller brush half and tighten
the screws.
Then ensure that the roller brushes are
safely locked in place.
Checking the sweeping mirror of the
side-brushes
Replacing side brush
Checking roller brush
Check the sweeping mirror of the
sweeping roller
Replacing the roller brush halves
44
EN
Summary of Contents for KM 105/100 R D
Page 2: ...2 ...