English
13
!
Please make sure that the connection or extension lines
are not damaged by being ran over, pulled or dragged.
Protect the connection lines from heat, oil, and sharp
edges.
!
Never touch the mains plug and the socket with wet
hands.
!
The connection between connection line and extension
line must not lie in the water.
!
All current-carrying components within the working area
must be jet-proof.
- The appliance may only be connected to an electri-
cal connection that was performed by an electrician
according to IEC 60364.
- Only connect the appliance to alternating current.
The voltage must comply with the voltage specified
on the typeplate.
- Minimum fuse protection of the socket 10 A (delay-
action fuse).
- To avoid electric accidents, we recommend to use
sockets with a series connected residual current
operated device (rated breaking current max. 30 mA).
- Warning:
Warning:
Warning:
Warning:
Warning: Inappropriate extension lines may be dan-
gerous. If you work outside, only use extension lines
that are approved and specifically labelled and pro-
vide of a sufficient conductor cross section:
1 to 10 m:
1 to 10 m:
1 to 10 m:
1 to 10 m:
1 to 10 m:
1.5 mm²
1.5 mm²
1.5 mm²
1.5 mm²
1.5 mm²
10 to 30 m:
10 to 30 m:
10 to 30 m:
10 to 30 m:
10 to 30 m:
2.5 mm²
2.5 mm²
2.5 mm²
2.5 mm²
2.5 mm²
- The plug and the coupling of an extension line must
be waterproof.
- Always unwind the extension line completely from the
cable drum.
Connection to the Water Conduit
Please observe the provisions of the local water supply
company.
Only use supply hoses (not included in the delivery) with
the following dimensions:
- minimum length 7.5 m
- minimum diameter ½‘‘
Please see the typeplate or the section ”Specificati-
ons” for the connection values.
Operation
!
Danger of life!
Vehicle tyres/tyre valves may be damaged and burst
by the high-pressure jet. A first sign is the discoloration
of the tyre. Damaged vehicle tyres/tyre valves are
hazardous. Always perform the cleaning with a distance
of at least 30 cm. Never touch the mains plug with wet
hands. Check the power cord and the mains plug for
damages prior to each use of the appliance. If the power
cord is damaged, please arrange immediately for the
exchange by an authorized customer service or a skilled
electrician.
Check the high-pressure hose for damages prior to
each use of the appliance. If the high-pressure hose is
damaged, replace it immediately.
!
Danger of injury!
Danger of injury!
Danger of injury!
Danger of injury!
Danger of injury!
Due to the water jet emerging from the high-pressure
nozzle, a recoil force acts on the trigger gun. Always
ensure a stable standing position and hold the trigger
gun and the spray jet firmly.
If necessary, wear protective clothes for the protection
from return spray.
Water Supply from the Water Main
• Connect a supply hose (not included in the delivery)
to the water connection of the appliance and to the
water supply.
• Open the water supply.
Water Supply from an Open Container
• Unscrew the coupling unit for the water intake.
• Fasten the suction hose with the filter (not included
in the delivery, see ”Special Accessories”) with screws
on the water connection of the appliance.
• Insert the filter into the container.
• Deaerate the appliance before using it.
• Unscrew the high-pressure line at the high-pressure
connector of the appliance.
• Turn on the appliance and let it run until bubble-free
water emerges at the high-pressure connector.
• Turn off the appliance, and fasten the high-pressure
hose with screws.
Preparing the Appliance
• Insert the mains plug.
• Set the main switch to ”I”.
Turning On the Appliance
• Press the safety button on the trigger gun, and pull
the lever.
Turning Off the Appliance
• Release the lever.
Press the safety button to prevent the appliance from
being inadvertently turned on during breaks or if you
leave the appliance.
Adding the cleaning agent
• Remove spray lance
No detergent in high-pressure mode
• Draw the cleaning agent suction hose out of the
housing to the required length.
• Hang the cleaning agent suction hose in the cle-
aning agent container.
If detergent has been added:
• Put the detergent suction hose into a container with
clear water, turn on the appliance for approximately
1 minute, and perform a clear rinsing.
Recommended Cleaning Method
1.Spray a small dose of the detergent on the dry sur-
face, and allow it to react (make sure the detergent
does not dry up).
2.Wash off the loosened dirt using the high-pressure
jet.
