Kärcher IVC 60/12-1 Ec H Z22, Manual

Page: 28 / 372

– 10
 Pull the safety filter sack towards the
rear.
Illustration
 Close tightly the opening of the suction
connection of the safety filter sack using
the closing lid.
Illustration
 Securely close the safety filter bag with
the attached cable tie.
 Remove the safety filter bag.
 Wipe the inside of the container using a
damp cloth.
 Dispose of the safety filter bag in a dust-
tight bag according to the statutory pro-
visions.
Illustration
 Affix a new safety filter bag.
Illustration
 Pull the safety filter sack over the con-
tainer.

Danger
Risk of explosion! The electrostatic earth-
ing between chassis and dirt container via
the spring bow must be ensured.
 Replace the battery and lock it with the
sliding bow.
몇
Warning
Crush hazard. Never hold your
hands between the dirt contain-
er and the intermediate ring or
put them near the lifting mecha-
nism while locking. Lock the container by
pressing the sliding bow with both hands.
 Plug in the pressure balancing.
Illustration
 Insert 2 flat-tip screwdrivers up to the
stop in the filter casing openings on the
suction head.

Push both flat-tip screwdrivers down
and lever out the filter casing.
 Remove the filter casing.
 Remove the supply air filter from the fil-
ter casing.
 Install new supply air filter into the filter
casing.
 Insert filter casing in the suction head
and snap in place.

Danger
First pull out the plug from the mains before
carrying out any tasks on the machine.
몇
Warning
All checking and work on electrical parts
must be performed by an authorized elec-
trician. In the event of continuing faults,
contact Kärcher customer service.
Note: In case of a failure (e.g. filter break-
age) the appliance must be turned off im-
mediately. The failure must be remedied
before the appliance is put into operation
again.
 Check the receptacle and the fuse of
the power supply.

Check the power cable and the power
plug of the device.

Turn on the appliance.
 Remove blockages in the suction noz-
zle, suction tube, suction hose, or flat
pleated filter.
 Replace the filled disposal bag
 Replace filled safety filter bag.
 Check the suction head and the recep-
tacle for proper seating.
 Ensure the filter cover properly locks
into place.
 Replace the flat pleated filter.
 Connect the pressure balancing at both
ends.
 Seal the unsealed suction nozzle with
connection bushing, see operation.
–
Thermal protection device has switched
the motor into the emergency mode due
to overheating.
 Allow appliance to cool down. Replace
the supply air filter.
Replacing the supply air filter
Troubleshooting
Suction turbine does not run
Suction capacity decreases
28 EN