Kärcher HDS-C 9/15, Original Instructions Manual

Page: 18 / 152

-
2
The sound level in the plant amounts to 71
dB(A). If parts (such as large sheets) that
amplify sound are shot blasted, it can give
rise to higher noise levels. If so, wear ear
plugs.
 Switch off the plant, turn the pro-
gramme selection switch at the operat-
ing panel to "0/OFF".
This SB washing system is to be used for
cleaning
– Vehicles and
– Trailers
with fresh water and detergents added to it.
It is wrong and therefore prohibited to use
the plant for cleaning
– human beings and animals. There is a
high risk of injury due to the high pres-
sure jet.
– Loose parts. These can get thrown off
due to the high pressure jet and can
cause damage to persons or other parts
of the plant.
ATTENTION
Risk of damage to the plant if water supply
is not of suitable quality. The system must
only be supplied with water in drinking wa-
ter quality.
Only for HDS-C 7/11 and HDS-C 9/15:
The plant may be used for diverting com-
bustible gases only in the open.
If the plant is to be housed under a roof or
in a closed room, then it must be connected
to a chimney to provide an outlet for the ex-
haust gases. If the plant is to be connected
to a chimney, then the burner needs to be
adjusted and the exhaust values must be
checked by the concerned chimney clean-
er.
– Coins are thrown in at the operating
panel (only for option ABS Münzprüfer)
and the washing programme is select-
ed.
– Cleaning is done using the hand-spray
gun.
 DANGER
Risk of injury, risk of burns. Washing oper-
ation only when the system is locked.
– The inner areas of the plant should only
be accessed by trained persons for
maintenance tasks. The door must be
closed when the plant is in operation.
 Switch off the plant, turn the pro-
gramme selection switch at the operat-
ing panel to "0/OFF".
The following washing programs are avail-
able:
– High pressure cleaning, without adding
detergents, cold water.
– High pressure cleaning, by adding de-
tergents, cold water.
– High pressure cleaning, without adding
detergents, hot water.
– High pressure cleaning, by adding de-
tergents, hot water.
– High pressure cleaning, without adding
detergents, cold water.
1 Thrown-in coins (option)
2 “Ready for use” indicator lamp
3 Program selection switch
 Select the washing programme using
the programme selection switch.
 Throw in the coin (only for ABS Mün-
zprüfer option).
1 Hand spray gun
2 Safety lever
3 Lever for trigger gun
 Unlock the trigger gun and pull the lever
of the gun.
Note:
The washing time also runs if the pro-
gramme selector switch is in the "0/OFF"
position.
1 Control board
2 Dosage valve for detergent
1 Main switch
2 Temperature controller
3 Switch for continuous operations/ coin
verifier
4 Freeze protection switch/ On
– Position 0: Unit has been switched off.
Frost proteciton is active
– Position 1: Unit is ready-to-use.
The water temperature is set at the thermo-
stat.
– 30...50 °C for slight dirt.
– 50...60 °C for cleaning machines and
cars.
The maximum permissible water tempera-
ture for SB operations is 60 °C. (See Tech-
nical Data for maximum possible water
temperature.)
Hearing protection
Behaviour in emergency situations
Proper use
Workstation
Operations
Switch-off in case of emergency
Washing programmes
Washing programme 1
Washing programme 2
Washing programme 3
Washing programme 4
Washing programme 5
Operations procedure
Settings
Settings at the switching cabinet
Main switch
Temperature controller
18 EN