– 8
Note:
If necessary turn in screw M8 appr. 5
mm inwards and therewith pull out sieve.
Clean sieve in water.
Push sieve inwards.
Slide the hose adapter all the way into
the lack of water fuse and secure it with
a fastening clamp.
Take out detergent suck supports.
Clean filter in water and reinstall.
Ready a catch bin for appr. 1 Liter oil.
Loosen release screw.
Tighten release screw.
Fill oil slowly up to the MAX marking.
Note:
Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions.
Danger
Risk of injury by inadvertent startup of ap-
pliance and electrical shock.
First pull out the plug from the mains before
carrying out any tasks on the machine.
–
No line voltage, see "Appliance is not
running".
–
Fuel tank empty.
Refill fuel.
–
Detergent tank is empty.
Refill detergent.
–
No power
Check power connection/conduit.
–
Low pressure nozzle is installed
Replace the low-pressure nozzle with
the high-pressure nozzle (stainless
steel).
–
Air within the system
Vent pump:
Set dosing value for detergent to "0".
With open hand spray gun turn device
on and off multiple times with the device
switch.
Note:
By dismantling the high pressure
hose from the high pressure connection the
venting process is accelerated.
If detergent tank is empty, refill.
Check connections and conduits.
–
Sieve in the water connection is dirty
Clean sieve.
Clean the fine filter; replace it, if neces-
sary.
–
Amount of water supply is too low.
Check water supply level (refer to tech-
nical data).
–
Pump leaky
Note:
3 drops/minute are allowed.
With stronger leak, have device
checked by customer service.
–
Leak in the high pressure system
Check high pressure system and con-
nections for tightness.
–
High pressure nozzle is installed
Replace the high-pressure nozzle with
the low-pressure nozzle (brass).
–
Filter in the detergent suck hose dirty
Clean filter.
–
Backflow valve stuck
Remove the detergent hose and loosen
the backflow valve using a blunt object.
Clean filter at the detergent suck hose
Oil change
Dispose of old oil ecologically or turn in at
a gathering point.
Troubleshooting
Indicator lamp "Ready for use"
turns off
Fuel indicator lamp glows
Indicator lamp for detergent glows
Appliance is not running
Device is not building up pressure
Device leaks, water drips from the
bottom of the device
Device turns on and off while hand
spray gun is closed
Device is not sucking in detergent
12
EN