COMMANDS
39
PId
ON | OFF
V 2.3
default OFF
KPC-1
/
KPC-2
/
KPC-2400
Packet
default OFF/OFF
KAM
/
KPC-4
Packet
When OFF, only those packets with a protocol ID of $F0 (pure AX.25) are displayed. When ON, all
packets are displayed. Some of the information in non-AX.25 (for example: TCP/IP, NET/ROM or
TheNet) packets can cause some computers to lock up.
PMode
x
(x =
N
one,
A
scii,
AM
tor,
CW
,
F
ec,
R
tty,
NA
vtex)
default NONE
KAM
This command is used to determine the mode the TNC will be in at power-on, If INTFACE is not
set to KISS or HOST. For example, if PMODE RTTY is used, the TNC will power-on in RTTY ready to
operate at the baud rate specified in RBaud, and no command prompt,
cmd:
, will appear. If not
using the Battery Backup or SmartWatch option this must be PERMed to be in affect after the
power is turned off.
See also: intface
POrt H
F |
V
HF (
KAM
)
1 | 2 (
KPC-4
)
default VHF
KAM
Packet
default 1
KPC-4
This command determines the radio port to which the I/O will be addressed at power-on. The
streamswitch characters can then be used to switch between radio ports. If not using the Battery
Backup or SmartWatch option this must be PERMed to be in affect after the power is turned off.
See also: streamsw
POStkey
n
(n = 0 – 15)
V 3.0
default 12
KAM
All Modes
This command sets the time delay after the last data has been sent to the radio before the PTT
line is released on the HF port of the
KAM
. The audio will be turned off n × .83 milliseconds before
releasing the PTT line.
See also: prekey
PRekey
n
(n = 0 – 15)
V 3.0
default 12
KAM
All Modes
This command sets the time delay between the assertion of PTT and the beginning of any audio
from the
KAM
HF port to the radio. The audio will begin n × .83 milliseconds after the PTT line is
activated.
See also: postkey
