DIRECTIVES
55
Ctrl-C U
the xmit unlock directive
v2.84
KAM
CW
Entering this combination during CW operation will unlock the receive speed to allow tracking of
the incoming signal. transmit speed will stay at current setting.
Ctrl-C X
KAM
CW/RTTY/ASCII/AMTOR/PACTOR
Exit. This directive will disconnect an existing link with another station and return the KAM to Pack-
et Mode (
cmd:
prompt). If you are not linked, it will simply return to Packet Mode. If you have
started to link to another station but have not yet received the link message, it will abort the link
attempt and return to Packet.
Ctrl-L
KAM
RTTY/AMTOR
Send RTTY or AMTOR letter shift character.
Ctrl-N
KAM
RTTY/AMTOR
Send RTTY or AMTOR figure shift character.
Ctrl-W
KAM
AMTOR
Sends special WRU sequence.
See also: wtext in the commands section
The following directives may be used only when your station is the Information Receiv-
ing Station (IRS) or when you are transmitting FEC PACTOR.
Ctrl-C Ø
This directive will set the speed to AUTO, allowing automatic speed changes based on link condi-
tions. (Not used in FEC)
Ctrl-C 1
This directive forces the link to a 100 baud speed.
Ctrl-C 2
This directive forces the link to a 200 baud speed.
