MESSAGES FROM THE TNC
64
Set MAXUSERS to 0/n
An attempt has been made to enter the WEFAX Mode without setting MAXUSERS to 0/n.
TOO MANY USERS
You have attempted to set MAXUSERS to a number too large. MAXUSERS may never be more
than 26 for any one port. The amount of RAM you have designated for PBBS and KA-NODE will
also limit the amount of RAM available for MAXUSERS.
USERS LIMITED BY MAXUSERS
You have attempted to set USERS to a number greater than MAXUSERS. The actual number of
users allowed is limited by MAXUSERS.
Value out of range
If the syntax of the command is legal, but the value specified is too large or too small for this
command, the value out of range message is used. A
$
is used to point the bad value.
Waiting acknowledgment
The time specified by FRACK has been exceeded without a proper acknowledgment for a
packet sent. A retry sequence is in progress.
was
Whenever one of the parameter is changed, the previous value is displayed. Example:
cmd:
AX25 OFF
was ON/ON
