COMMANDS
28
MORse
code TX RX
V 2.84
KAM
CW
Where: code is entered as a combination of
*
and
-
characters; TX represents a keyboard charac-
ter entered in hex or decimal and RX denotes the character(s) displayed upon reception, entered
in hex, decimal or two alpha characters.
This command is used to define the desired keyboard character and display character(s) for each
code listed in the table below. Only those codes listed may defined using the MORSE command;
standard MORSE codes may not be redefined.
For example, suppose you wish to define the "wait" code *-*** by the keystroke
^
and have it
displayed as
BB
. You would enter:
cmd:
MORSE *-*** $5e $4242 <CR>
(4 precedes hex codes)
If you try to define a previously defined code, you will get the message
TX CHARACTER ALREADY
DEFINED
. In order to delete an entry use the command MORSE code 00 0000 to clear the code
and then redefine it. Standard codes may not be redefined. Refer to the ASCII Chart at the end of
this book for a listing of hex codes. Codes available for definition by MORSE are:
MORSE CODE
TX
RX
MORSE CODE
TX
RX
**--
---*
***-*
**-*-
*-***
*-*-*
*--**
*---*
-**--
-*-*-
-*---
--*-*
---*-
*-***-
$00
$00
$21 (!)
$00
$25 (%)
$2B (+)
$00
$00
$00
$26 (&)
$00
$00
$00
$00
$00
$00
$534E (SN)
$00
$4253 (AS)
$4152 (AR)
$00
$00
$00
$4B41 (KA)
$00
$00
$00
$00
*-*-
-----
**-**
**--*
*-**-
*-*--
*--*-
-**-*
-*-**
-*--*
--**-
--*--
***-*-
$2A (*)
$00
$00
$00
$00
$00
$00
$2F (/)
$00
$28 (()
$00
$00
$23 (#)
$4141 (AA)
$00
$00
$00
$00
$00
$00
$2F (/)
$00
$28 (()
$00
$00
$534B (SK)
If SCREENL is set to a value from 1 to 60. the above table will be displayed in one column instead
of two columns.
See also: cw, prosign
