COMMANDS
31
MYNode
xxxxxx-n
V 2.8
default MYCALL
All Units
KA-NODE
This command tells the TNC what callsign is to used when a remote station is connecting to the
KA-NODE. Enter up six characters, using a callsign (plus an SSID) which is different than that used
for MYCALL, MYALSIAS, MYPBBS or MYGATE.
See also: digipeat, ndwild, unmnodes
MYPbbs
xxxxxxx-n
V 3.0
default MYCALL
All Units
PBBS
Enter up to six characters which will be used as the operating address for your Personal Packet
Mailbox. Enter up to six characters, using a callsign (plus an SSID) which is different than that
used for MYCALL, MYALIAS, MYNODE or MYGATE.
See also: ppbs
MYPTcall
xxxxxxxx
V 6.0
default mycall
KAM
PACTOR
Establishes callsign used for PACTOR link. Up to 8 characters/numbers may be entered.
MYR
emote xxxxx
V 5.0
default blank
?????
MYSel4
xxxx
V 3.0 –
NOT IN V 5.0
KAM
AMTOR
The 4 character selcal specified by xxxx will be recognized, when operating in AMTOR Mode A, as
your station identification. The convention used for AMTOR selcals is to use the first letter and
then the last three letters of your callsign. If your callsign has only three letters, use the first letter
twice. For example use WWXI for W0XI or use DCXJ for DC7XJ. The MYSEL4 will also accept 4 or 5
digit numbers and generate the corresponding 4 character selcal automatically from these num-
bers. (See the AMTOR section in the Operating Manual.)
See also: amtor fec, mysel7,
myselcall
