COMMANDS
23
K
V 2.84
immediate
All Units
Packet
This single letter command is synonymous with CONVERS. It is included as a single-keystroke con-
venience for entering Convers Mode.
See also: convers
KNtimer
n
(n = 0 – 255)
V 2.85
default 15
All Units
KA-NODE
If there is no activity (data) on a KA-NODE circuit for n minutes, the KA-NODE will disconnect both
the input and output sides of the KA-NODE circuit. Setting KNTIMER to 0 disable this feature.
See also: rnrtime
KNX
con [n]
(n = .....)
V 5.0
default 15
?????
Lamtor
immediate
KAM
AMTOR
This command sets the TNC in Listen AMTOR Mode. The TNC will receive either FEC or ARQ sig-
nals. The selcall being used by a station sending ARQ phasing signals may also be decoded when
in this mode. Such calls will appear on the display as the same four letter group appearing repeti-
tively on the display.
See also: amtor, fec, misschar
LCok
ON | OFF
default ON
All Units
All Modes
When ON, no character translation occurs in the TNC. If OFF, lower case characters will be trans-
lated to upper case before being output to the terminal from the TNC. This case translation is dis-
abled in Packet Transparent Mode.
LCRtty
ON | OFF
default OFF
KAM
RTTY/ASCII/AMTOR
When ON, lower case characters can be sent and received in RTTY, ASCII and AMTOR Modes. If
you are sending lower case RTTY, the other station will print lower case RTTY only if its LCRTTY pa-
rameter is also ON. This is accomplished by using the RTTY null character as a special shift charac-
ter; this is the same method used in RTTY to send the Russian Cyrillic alphabet. If USOS is ON, a
received space will cause a shift to the lower case.
See also: usos
