Kanomax Anemomaster 6162, Operation Manual

Page: 48 / 52

8. Troubleshooting
42
8. Troubleshooting
* Before you send the unit for repairs, please check the followings once again.
8.1 Checking Power Source
No. Symptom Possible Cause / Solution Refer to
1.
Even when your turn the power
switch ON, nothing is displayed.
- The batteries may be drained.
⇒ Need new batteries.
Page 5
2.
Although batteries are used, nothing
is displayed on the screen.
- The brightness adjustment has not been done
properly.
⇒ Adjust the brightness by the volume.
Page 2
3.
The dry cell dies faster than the
specification.
- The polarity of the batteries are not correct.
⇒
Check the batteries.
Page 5
4. The display screen blinks.
- It shows that the batteries are drained.
⇒
Need new batteries.
Press BATT key and check the remaining level of
the batteries.
Page 11
8.2 Checking the Initial Operation
No. Symptom Possible Cause / Solution Refer to
1. The display screen is dark or pale.
- The brightness adjustment has not been done
properly.
⇒
Adjust the brightness by the volume.
Ambient temperature affects the brightness.
Page 2
2. The backlight is not ON.
- In a bright place it is sometimes difficult to
check if the backlight is ON.
⇒
RIGHT Switch ON
Page 2
3.
When the instrument is turned ON, it
goes to calculation mode
automatically and “ready” is
displayed.
- Calculation program is set.
⇒ PROGRAM OFF
Page 21
4.
Even if I select MEASUREMENT in
the menu, the calculation mode
selection screen does not display. In
stead measurement condition setting
screen displays.
- Calculation program is set.
⇒ PROGRAM OFF
Page 21
5
“PROBE” keeps to be displayed on
the screen.
- Probe is not connected.
⇒ Connect a probe.
Page 6