Kambrook KIR931 series, Instruction Booklet

Page: 13 / 16

12
Care, Cleaning and Storage
The Kambrook FabriGuard One
Temperature Iron has a self-clean
function which is designed to assist with
the removal of scale and impurities.
This function helps to maintain optimum
performance of your iron.
• Fill the water tank up to the MAX level
as indicated on water tank
• Slide the steam control switch to the
‘NO STEAM’ setting (See Fig. 1–page 9)
• Place the iron on its heel on a flat
surface. Insert the plug into the power
outlet and switch the outlet on
• Allow the iron to heat up to
temperature
• Switch the iron off at the power outlet
and remove the plug
• Hold the iron horizontally over a sink
and firmly press and hold the self-
clean button. Steam and boiling water
will emit from the holes in the soleplate
• Hold iron in this position until all water
has dripped out of the water tank
• Once the water tank is empty, insert
the plug into the power outlet and
switch the outlet on
• Allow the iron to heat up and the
soleplate to dry
• Once the heating light has turned
off, test the iron on an old piece of
cloth to remove any residual water
stains that may have formed on the
soleplate
• Switch the iron off at the power outlet
and remove the plug
• Allow the iron to cool completely
before storing
NOTE:
Repeat the self-clean
process if the iron still contains a
lot of impurities.
CAUTION:
Do not store
the iron with water in the
water tank. Always empty
the tank after use.
Cleaning the Anti-Scale System
The Kambrook FabriGuard One
Temperature Iron has a double anti-scale
system. The purpose of this feature is to
prolong the life of your iron by reducing
the build up of scale and other impurities
in the water tank. The system consists
of a built-in cartridge and a removable
filter. The anti-scale filter is located inside
the water tank inlet and can be easily
removed for cleaning.
To remove the filter, open the water tank
inlet and rotate the tab of the filter in an
anti-clockwise direction from the locked
position to the unlocked position
(See Fig. 5 and 6) and pull the filter from
inlet. The anti-scale cage and filter can
be disassembled and rinsed in water.
Once the anti-scale cage and filter has
been cleaned and reassembled, insert
the filter back into the water inlet in
the unlocked position. Once correctly
inserted, rotate clockwise into the
locked position. Ensure that the filter is
fully inserted and sits below the lip of the
water tank inlet.
Fig. 5
•
Filter correctly inserted and in locked
position