Kalmar ContChamp DRD S Series, Technical Handbook

Page: 289 / 298

ContChamp DRD-S
Technical Handbook
Periodic supervision
3 S. Grupp 90
9407
04-10
General survey
To extend the service life of the truck and to prevent the risk of
faults causing injury to personnel or damage to equipment, the
truck must be subjected to regular periodic supervision.
If the truck is used under conditions in which road traffic regula-
tions are applicable, the special maintenance instructions issued
by the authorities must be followed.
Special procedures are required on trucks used under difficult
conditions, such as in difficult terrain or for the transport of hot
goods. These procedures are not dealt with here.
The intervals at which service measures are carried out can be
determined on the basis of the operating hour meter readings.
When carrying out a 1000-hour service, it is advisable to work in
the following order:
1. Every 1000 hours
2. Every 600 hours
3. Every 200 hours
The same procedure also applies to work carried out in a
600-hour service.
General survey chart
Maintenance intervals, hours
Operating
time 1000 600 200 Anm
200
400
600
800
1000
1200
1400
. . .
2000
. . .
z
z
z
z
z
z
z
z
z
z
z
z
z
z
z
Guarantee service after
50 hours.
Work in accordance with
list below:
WARRANTY SERVICE at 50 working hours
1. 200 hours service according to Technical Handbook, group 90
2. Perform and fill in control chart in the Warranty certificate
3. Changing of oil in engine, gearbox, drive axle, rotator reduction gear and
reduction gear on the top lift.
4. Changing filter in engine, gearbox and hydraulic system,
(all filters incl. WDB, servo filter etc)
5. Valve clearance adjustment (engine)
6. Check all bolt joints (see also SI94-003)