Full Digital Color Doppler Ultrasonic Diagnostic Instruments (Vet) User’s Manual V1.01
- 54 -
1.
Press the
M
key on the control panel to enter the M mode.
2.
Press the
Caliper
key to activate the measurement, and the measurement menu displays on the top left
of the screen.
3.
Select [Time] on the menu by moving the trackball and press
Set
to confirm. A marker displays on the
image.
4.
Move the marker to the starting point by using the trackball, press
Set
to fix the marker and the second
marker displays.
You can also press
Change
on the control panel, move the trackball to adjust the starting point.
5.
Move the second marker to the end point by using the trackball and press
Set
. The measurement result
displays in the result box.
6.
Repeat step 3-5 to perform the next time measurement.
10.5.2.3 Heart Rate
It is used to measure the time interval between heart cycles based on the number of heartbeats per minute on
the M mode image.
You can preset the heart cycle in
Preset
-> [Measure Preset] -> [HR].
Steps:
1.
Press the
M
key on the control panel to enter the M mode.
2.
Press the
Caliper
key to activate the measurement, and the measurement menu displays on the top left
of the screen.
3.
Select [HR] on the menu by moving the trackball and press
Set
to confirm. A marker displays on the
image.
4.
Move the marker to the starting point by using the trackball, press
Set
to fix the marker and the second
marker displays.
You can also press
Change
on the control panel, move the trackball to adjust the starting point.
5.
Move the second marker to the end point by using the trackball and press
Set
. The measurement result
displays in the result box.
6.
Repeat step 3-5 to perform the next heart rate measurement.
10.5.2.4 Slope Rate
It is used to measure the change in distance over time on the M mode image.
Steps:
1.
Press the
M
key on the control panel to enter the M mode.
2.
Press the
Caliper
key to activate the measurement, and the measurement menu displays on the top left
of the screen.
3.
Select [Slope] on the menu by moving the trackball and press
Set
to confirm. A marker displays on the image.
4.
Move the marker to the starting point by using the trackball, press
Set
to fix the marker and the second
marker displays.
You can also press
Change
on the control panel, move the trackball to adjust the starting point.
5.
Move the second marker to the end point by using the trackball and press
Set
. The measurement result
displays in the result box.
6.
Repeat step 3-5 to perform the next slope rate measurement.
10.5.3 Color/PDI Mode Measurements
The operations of Color/PDI mode and the B mode measurements are similar. For details, please refer to
Section 10.5.1 B Mode Measurements.
