KAESER M100, Operator'S Manual

Page: 109 / 384

9.3.7 Option da, db, dc, dd
High moisture content in the compressed air
Possible cause Remedy Where can I get help?
Specialized
workshop
KAESER
Service
Blocked condensate drain on
the cyclone separator.
Clean the cyclone separator dirt
trap or replace the strainer and
nozzle if necessary. See chap‐
ter 10.8.2.
– X
Tab. 81 Fault: High moisture content in the compressed air
9.4 Option ga, gb
Generator faults and alarms
9.4.1 There is no voltage or too low a voltage from the generator
Possible cause Remedy Where can I get help?
Specialized
workshop
KAESER-
Service
Defective drive belt. Have replaced. X X
Generator / regulator defective Have repaired. X X
Overload protection switch trig‐
gered because of overload or
defect.
Check the power requirement of
the connected consumers and
reduce if necessary; check the
consumers for short circuits.
X –
Check the overload protection
switch and have replaced if nec‐
essary.
X X
Engine speed too low. Have reset to rated speed. X X
Generator not switched on. Switch on the generator. – –
The compressor's working pres‐
sure is set too high, engine
overloaded, speed drops off
Have the working pressure ad‐
justed.
X X
The engine power is reduced
because of climatic conditions or
other effects.
Keep the generator and com‐
pressor load below the rated
power
– –
Tab. 82 There is no voltage or too low a voltage from the generator
9.4.2 Generator voltage too high
Possible cause Remedy Where can I get help?
Specialized
workshop
KAESER-
Service
Generator / regulator defective Have repaired. X X
9 Fault Recognition and Rectification
9.4 Generator faults and alarms
No.: 9_6999 23 USE
Operator Manual Screw Compressor
M100
97