KAESER M100, Operator'S Manual

Page: 184 / 384

Changing the belts
1. Undo the nut
5
until the belt
6
can be slipped off the pulleys.
2. Take off the belt.
3. Check the pulleys for dirt and wear.
Clean the pulleys.
Worn pulley: Have the pulley replaced.
4. Without using force, place the new belt over the engine and generator pulleys.
5. Turn the tensioning nut
5
to tighten the belt
6
until the tensioning dimension
A
corresponding
to the set distance is reached.
6. Tighten the locknuts
2
and
5
.
7. Replace the belt guard.
8. Reconnect the negative battery terminal.
9. Close the doors.
10. Run the compressor under LOAD operation for 15–20 minutes.
11. Check the belt again and re-tension if necessary.
■ Check the belt again after a further 2 operating hours.
■ A belt that has been replaced may not be used again.
Old belts should be disposed of in accordance with the latest environmental regulations.
10.8.9 Option oe
Draining liquid accumulation within the machine
The so-called "closed floor pan" contributes to the protection of the environment by preventing a
contamination of the soil in the event of leaking operating fluids.
Liquid accumulations within the machine's body can also cause corrosion or electrical faults.
Liquid accumulations must be removed as quickly as possible in order to avoid potential machine
faults.
For draining the liquid, maintenance openings have been added to the floor panel of the machine
which are closed with bungs.
Material Receptacle
Cleaning cloth
Precondition The machine is shut down.
The machine is standing level.
The machine is secured against moving.
The machine is fully vented, the pressure gauge reads 0 psig.
The machine is cooled down.
All compressed air consumers are disconnected and the air outlet valves are open.
1. Place a receptacle underneath the maintenance opening(s).
2. Unscrew and remove the bung(s) from the maintenance openings.
The liquid will drain.
3. Clean the bungs and maintenance openings.
10 Maintenance
10.8 Maintenance for Optional Items
172
Operator Manual Screw Compressor
M100
No.: 9_6999 23 USE