blueplanet hybrid 10.0 TL3
Page 21
Procedure for
mounting the wall bracket
The wall bracket must be removed from the back of the device. (cable ties)
1.
Remove the wall bracket from the device.
2.
Determine the mounting position of the device. Check compliance with minimum distances (Fig. 7).
3.
Hold the wall bracket horizontally in position as a template.
4.
Mark the position of the drill holes using the recess in the wall bracket, or mark them according to the
dimensions in Fig. 9.
5.
Determine the size of the drill holes according to the fixing material and drill holes.
6.
Fix the wall bracket to the wall with suitable fixing material (see 6.1).
7.
Check the wall bracket for a firm seat.
6.5
Installing and securing the device
CAUTION
Risk of injury from improper lifting and transport
If the device is lifted improperly, it can tilt and result in a fall.
› Always lift the device vertically.
› Use a climbing aid for the chosen installation height.
› Wear protective gloves and safety shoes when lifting and lowering the device.
NOTE
Power reduction due to heat accumulation!
If the recommended minimum clearances are not observed, the device may reduce the power due to
insufficient ventilation and the resulting heat build-up.
› Observe minimum clearances and provide for sufficient heat dissipation.
›
All objects on the device housing must be removed during operation.
› Ensure that no foreign bodies prevent heat dissipation following device installation.
Lifting and installing the device
The mount has been installed.
1.
The device is tilted slightly to the rear. Both hooks of the wall bracket must engage into the bolts of the outer
cooling fins. When inserting, make sure that the hooks are not bent. When the bolts are hooked into the wall
bracket, the device is carefully tilted down until it is parallel to the wall.
Fig. 10: Installation
EN
EN
Screw connection
