Kaco blueplanet gridsave 110 TL3-S, Manual

Page: 51 / 93

Country-
spec. Set-
tings Level Display/
settings
Action in this menu/meaning
4 1 2 3 4
Write access
Status
F
Allow Modbus TCP write access.
Enabling the write access allows system critical settings to be changed
over Modbus TCP. Really enable write access?
F Confirm the action field.
4 1 2
3
4
MQTT
NOTE: The MQTT protocol is used to implement the advanced
functions between the Segment Controller and the inverter (in
particular, firmware updates, distribution of device configura-
tions etc.).
4 1 2 3 4
Broker IP 1. Displays the IP address transmitted by the Segment Controller.
. NOTE: The standard settings allow for successful commu-
nication with the Segment Controller.
2. Confirm the action field.
4 1 2 3 4
Broker port
4 1
2
3 4
RS485
NOTE: Option to parameterise the RS485 interface. The pa-
rameters of the RS485 (CON901) are (as with all KACO invert-
ers): 9600 Baud, 8n1 and cannot currently be re-configured via
the web interface.
4 1 2 3 4
RS485 address
NOTE: The address must not be the same as that of any other
device or data logger.
F Assign a unique RS485 bus address to the device.
Bus termination is carried out on the HMI board by means of a dip-
switch
F
Confirm the action field.
4 1 2 3 4
Power Control Input screens for power regulation
4 1
2
3
4
Power Limitation
NOTE: The output power of the device can be set permanently
to a lower value than the maximum output power by the in-
ternal power limitation. This may be necessary in order to
limit the maximum power rating of the plant at the grid con-
nection point, upon the grid operator's request.
4 1 2
3
4
Internal
NOTE: Opportunity to limit the power internally More detailed
information at:
[See section 10.4.1
}
Page 79]
4 1 2 3 4
Power Limitation
Status
F Specify the activation status.
4 1 2 3 4
Maximum apparent
power Slim
1000 -125000 /
[See sec-
tion 4
}
Page 12] [VA] /
100 [VA]
NOTE: The max. apparent power limits the internal power of
the device.
F Enter the value or set the value using the slider.
4 1 2 3
4
Maximum active power
Plim
1,0 – 100,0 [%
Slim] / 100[% Slim] /
0.1
Password protection
Status
NOTE: Max. Active power limits the internal power of the unit
F Enter the value or set the value using the slider.
Manual Configuration and operation | 9
blueplanet gridsave 92.0 TL3-S blueplanet gridsave 110 TL3-S blueplanet gridsave 137 TL3-S
Page 51
EN-US