Kaco blueplanet 110 TL3, Manual

Page: 20 / 119

1. Lift the device using the lateral openings. Have regard to the position of the device's center of gravity!
. NOTE: Do not lift the device by the lid or cover!
2. Fit the device onto the upper mount by means of the mounting bracket. Fit the device onto the lower mounting
bracket in full so that the device sits flush with its rear side on the mount. ( [See figure 17 [ } Page 18]).
3. Insert the screw provided into the lug of the mount and [ T30 / 17.70 In-Ibs ] ( [See figure 16 [ } Page 18]).
.
NOTE: Alternatively: At this point, the screw mentioned above can be replaced with a special-purpose
screw for protection against theft.
ð The device is installed. Proceed with the electrical installation.
CAUTION
Damage to property due to condensation build-up
If the device is pre-assembled, moisture can get into the internal area via the dust-proof screw connections. The conden-
sate that forms can cause damage to the device during installation and start-up.
ü Keep the device sealed during pre-assembly and don't open the connection area until installation.
1. Seal off any screw fittings using sealing covers.
2. Check the interior space for any condensation water prior to electrical installation and, if necessary, allow it to dry
out sufficiently.
3. Immediately remove any moisture from the housing.
6 | Assembly and preparation Manual
KACO blueplanet 110 TL3 KACO blueplanet 125 TL3 Page 20
EN-US