1
Hold down the lock button (blue) at the
center of the [POWER ON/OFF(CHG)] switch
to set to “OFF(CHG)”.
2
Attach the supplied battery.
Slide it in until you hear a click.
3
Connect the supplied AC adapter to the
[DC] terminal.
Open the cover of the [DC] terminal and connect
as shown in the diagram.
4
Connect the AC adapter to a power outlet.
0
The [POWER/CHG] lamp blinks during
charging and will go out after charging is
complete.
0
Remove the AC adapter after charging is
complete.
Memo :
0
Blinking of the [POWER/CHG] lamp during
charging indicates the charge level.
[POWER/CHG] Lamp
Charge Level
Orange blinking
(4 times per second)
Less than 25%
Orange blinking
(3 times per second)
Less than 50%
Orange blinking
(2 times per second)
Less than 75%
Orange blinking
(1 time per second)
Less than 100%
Light goes out
Fully charged
Removing the Battery
.
1
2
MODE
POWER
ON
OFF
(CHG)
1
Hold down the lock button (blue) at the
center of the [POWER ON/OFF(CHG)] switch
to set to “OFF(CHG)”.
2
While pressing and holding the [BATT.
RELEASE] button, push up and remove the
battery in the direction of the arrow.
Caution :
0
Do not remove the battery when the [POWER
ON/OFF(CHG)] switch is “ON”.
0
Do not insert or remove the DC cable when the
battery is in use.
0
Leaving the camera recorder unused with the
battery inside will deplete the battery power
even if you set the [POWER ON/OFF(CHG)]
switch to “OFF(CHG)”. Remove the battery if
you are not using the camera recorder.
Estimated Charging and Continuous
Operating Times
o
Charging Time (supplied SSL-JVC50 battery
pack)
Approx. 4 h
Memo :
0
Use up the charge completely before you
charge the battery. If the battery is not fully
discharged before charging, the battery
capacity may drop after repeated cycles.
0
If the battery capacity drops due to repetitive
shallow charging and discharging, it may be
recovered by using up the charge completely
and then fully charging the battery again.
0
If you charge the battery immediately after using
while the battery is still warm, it may not be fully
charged.
0
It is recommended that you charge the battery
in an environment between 10 °C and 35 °C
(50
°F and 95 °F). The battery may not be fully
charged or the charging time may be prolonged
if charged under low temperatures (below 10 °C/
50 °F).
o
Continuous Operating Time (supplied SSL-
JVC50 battery pack)
Approx. 2 hrs 45 mins
Memo :
0
Actual operating times may differ depending on
the age of the battery, charging condition, and
operating environment.
0
Operating time is shortened in cold
environment.
0
The operating time may shorten when power
zoom is used, accessories are connected, or
when the LCD monitor is frequently used.
0
For purchase of spare batteries and battery
charger, consult your nearest JVC dealer.
Precautions for Batteries
0
Store the battery in a cool and dry place when
not in use. Do not expose the battery to high
temperatures (such as in a car under direct
sunlight). This will cause battery leakage and
shorten the battery life.
0
If the operating time shortens drastically even
after charging, the battery may be reaching the
end of its life. Replace the battery with a new
one.
27
Pr
ep
ar
ati
ons
Summary of Contents for GY-HM600E
Page 146: ...146 ...
Page 147: ...147 ...
Page 148: ... GY HM600U GY HM600E HD MEMORY CARD CAMERA RECORDER 2014 JVC KENWOOD Corporation LST1424 001E ...