JVC GW-SP100E, Instructions Manual

Page: 27 / 72

27
USB Host Terminal
Future upgrade will allow use of this.
AUX Input Terminal ( Φ 3.5 mm)
USB Mini Terminal
Audio Input Terminal 1, 2
(XLR 3pin x 2)
Cable Connector for Gimbal Unit
TC Output Terminal (BNC)
Connect the [TC OUT] terminal of the master
device with the [TC IN] terminal of the slave
device.
TC Input Terminal (BNC)
Connect a time code signal generator to
synchronize with the SMPTE/EBU LTC time
code. When using as slave unit, connect the
[TC OUT] terminal of the master device.
Synchronization with the external time code
can be attained by inputting the external time
code to the TC input terminal and setting
[TC/UB] [TC Generator] to "Free Run".
33
32
31
Memo :
●
Operation by the control unit is required to
switch to the USB mode.
35
36
37
38
33
32
34
35 36 37 38
31
■
Synchronizing signal used
SD synchronizing :
signal
HD synchronizing :
signal
BB (Black Burst) signal
Supports SMPTE170M
(RS-170A)-NTSC
Supports ITU-R BT.470-6 PAL
HDTV tri-level synchronizing
signal
■
Phase Items to Synchronize
The phase items to be synchronized may vary
depending on the input synchronizing signal
and output video signal.
Output Video Signal
Input Synchronizing
Signal
Tri-sync
BB
1080i
1080/
30p
25p
1080/
24p
1080/
24psF
60p/50p (SDI OUT) V V *1 *1 V
60i/50i (SDI OUT) H, V, F V *1 *1 V, F
30p/25p (SDI OUT) V H, V *1 *1 V
24p (SDI OUT)
− −
H, V V
−
60i/50i (AV OUT) V, F V *1 *1 H, V, F
Memo :
●
When the camera system’s video is locking
to the external synchronizing signal, “Sync
Locking” appears on the screen.
●
After locking to the external synchronizing
signal is complete, the display disappears
and recording can be performed.
●
If genlock is disconnected due to reasons
such as no signal input while genlock is in
operation, “Sync Unlocked” is displayed.
●
If there is genlock signal input but the signal
format is not supported, “Invalid Sync” is
displayed.
H : Horizontal Phase
V : Vertical Phase
F : Field Phase
*1: Out of phase
34
Genlock Terminal (BNC)
Input external synchronizing signals, and
synchronize the camera video or playback
image with the external signal.