12
READY
Place a cup under the replaceable hot water nozzle (16).
Open the steam / hot water draw-off tap (14) (Fig. 13).
The illuminated ring (2) is active.
For example,
140 ML
WATER
Adjust the required water quantity by turning the rotary switch
(1).
For example,
200 ML
WATER
If the required water quantity is reached, the following message
is displayed:
CLOSE TAP
Close the steam / hot water draw-off tap (14).
READY
Before CLOSE TAP water may still escape the system.
12. Drawing off steam
Install the replaceable steam/frothing nozzle (Fig. 6). This is
included in your Welcome Pack. Do not replace the re-
placeable steam/hot water nozzle (15) directly after drawing
off steam, because the nozzle is hot after the draw-off
operation.
Steam can be used for heating liquids and frothing milk for
cappuccino. Make sure that the replaceable steam/frothing
nozzle (15) is pushed upwards when liquids are heated. Push
down the frothing aid to froth liquids.
During frothing some water will escape the system before
the actual frothing process. This does not affect the result,
e.g. when frothing milk.
At the start of the steam draw-off operation there can be
splashing The steam nozzle becomes hot. Avoid direct
contact with the skin!
READY
Place a cup under the steam/frothing nozzle (15) and immerse it
in the milk to be frothed or the liquid to be heated.
Press the steam pre-selection key
(8).
HEATING UP
STEAM
READY
To draw off steam, open the steam/hot water draw-off tap (14)
(Fig. 13).
The illuminated ring (2) is active.
You can adjust the steam draw-off time individually by turning
the rotary switch (1) until the required SEC are displayed.
For example,
35 SEC
If you do not change the steam draw-off time settings using the
rotary switch (1), the machine will use the settings last adjusted
During the steam draw-off operation, the message STEAM is
displayed
When the steam quantity is reached, the message CLOSE TAP is
displayed
Close the steam / hot water draw-off tap (14).
READY
Press the steam draw-off pre-selection key
(8) again to
draw off steam.
Before CLOSE TAP, steam may still escape the system.
