Juniper T4000 -, Hardware Manual

Page: 320 / 396

especial, cerradura con llave, o algún otro medio de seguridad, y que está
bajo el control de la autoridad responsable del local.
Varning! Denna enhet är avsedd för installation i områden med begränsat
tillträde. Ett område med begränsat tillträde får endast tillträdas av
servicepersonal med ett speciellt verktyg, lås och nyckel, eller annan
säkerhetsanordning, och kontrolleras av den auktoritet som ansvarar för
området.
Related
Documentation
Installation Safety Warnings for Juniper Networks Devices on page 301
•
•
Maintenance and Operational Safety Warnings for Juniper Networks Devices on page 309
•
General Electrical Safety Warnings for Juniper Networks Devices on page 315
•
DC Power Electrical Safety Warnings for Juniper Networks Devices on page 321
Preventing T4000 Electrostatic Discharge Damage
Many router hardware components are sensitive to damage from static electricity. Some
components can be impaired by voltages as low as 30 V. You can easily generate
potentially damaging static voltages whenever you handle plastic or foam packing
material or if you move components across plastic or carpets. Observe the following
guidelines to minimize the potential for electrostatic discharge (ESD) damage, which
can cause intermittent or complete component failures:
• Always use an ESD wrist strap or ankle strap, and make sure that it is in direct contact
with your skin.
CAUTION: For safety, periodically check the resistance value of the ESD
strap. The measurement should be in the range of 1 to 10 Mohms.
•
When handling any component that has been removed from the chassis, verify that
the equipment end of your ESD strap is attached to one of the ESD points on the
chassis, which are shown in
Figure 143 on page 297 and Figure 144 on page 298 .
• Avoid contact between the component and your clothing. ESD voltages emitted from
clothing can still damage components.
•
When removing or installing a component, always place it component-side up on an
antistatic surface, in an antistatic card rack, or in an electrostatic bag (see
Figure 145 on page 298 ). If you are returning a component, place it in an electrostatic
bag before packing it.
Copyright © 2013, Juniper Networks, Inc. 296
T4000 Router Hardware Guide