18 | Juniper Networks, Inc.
After you have saved and applied a configuration to the IDP Sensor, exit the
ACM by closing the Web browser window.
Networking
• Speed and duplex settings for IDP appliance
interfaces
• Enable/configure VLAN interfaces
• Enable/configure virtual routers
• Management interface
• Forwarding interfaces (The IDP 10 appliance is limited
to a total of four forwarding interfaces.)
• Routing table (In proxy-ARP or router mode, if you are
using multiple subnets in your protected network, you
must configure static routes on the IDP appliance to
these subnets. Without these static routes, incoming
traffic to those subnets can be lost. Alternatively, you
can create a static route from the IDP appliance to an
internal gateway that contains inbound routes to the
protected subnets.)
System
• Enable/configure DNS
• Set Time and Time Zone
• Enable/configure NTP
• Enable/configure RADIUS
• Enable/configure SNMP
• Enable/configure SSH access
Management
• IP address of the Management Server for this Sensor
and OTP
• Sensor VIN
________________________________________
• Enable/configure ACM access
Done
View the current configuration and then:
• Save all changes
• Apply the configuration to the IDP appliance
• Reboot the IDP appliance
Section
Configuration Information
