Known Problems and Limitations
51
Release 11.0.2
Service Manager
After you activate an independent IPv6 service and issue either of the following
commands on the default virtual router or any other virtual router, except the
one on which the subscriber session is active, no output is displayed in the CLI
interface: [Defect ID 181929]
show service-management subscriber-session
subscriberName
interface
interfaceType interfaceSpecifier
show service-management subscriber-session
subscriberName
interface
interfaceType interfaceSpecifier
service-session
serviceName
This problem also occurs when a subscriber is authenticated using a RADIUS
server for a combined IPv4 and IPv6 service in a dual stack.
Work-around
: To avoid this problem, use the
show service-management
owner-session
ownerName ownerId
command to display subscriber session
information based on the session owner, instead of the
show
service-management subscriber-session
subscriberName
interface
interfaceType
command to display details on subscriber sessions.
SONET
You cannot use the highest sensitivity bit-error rate setting (a value of 9)
associated with APS/MSP alarm when you issue the
threshold sd-ber
command to configure a cOCx/STMx line module with cOC12-APS-capable
IOAs. [Defect ID 72861]
Work-around:
Use only a value in the range 5–8 when you issue the
threshold
sd-ber
command for this module combination, as in the following example:
host1(config)#
controller sonet 2/1
host1(config-controll)#
aps group boston
host1(config-controll)#
aps protect
host1(config-controller)#
threshold sd-ber 6
SRC Software and SDX Software
When multiple IPv6 interfaces are configured with policies attached from SRC,
only some of the IPv6 interfaces have the policies attached. [Defect ID 179498]
Changing the SSCC status (enable/disable) while IPv6 interfaces are configured
might cause the SRP to reset. [Defect ID 179537]
