JunosE 11.0.2 Release Notes
8
Early Field Trial Features
Early Field Trial Features
The features described in this section are present in the code but have not yet been
fully qualified by Juniper Networks. These features are available only for field test
purposes in this release. If you use any of these features before they have been fully
qualified, it is your responsibility to ensure that the feature operates correctly in
your targeted configuration.
ANCP
Support for Learning the Partition ID from an Access Node
ANCP running on a network access server (NAS) can now learn the partition ID
from an access node and use this partition ID to communicate with the access
node. In lower-numbered releases, ANCP running on a NAS did not keep track
of the partition ID of an access node, and always communicated with partition
ID 0. This learning option in the virtual router enables the NAS to learn the
partition ID from all the access nodes. The learned partition ID can be used to
send messages to establish adjacency.
To learn the partition ID, the NAS has to wait until it receives the first
GSMP_SYN message from an access node.
The following command has been added to enable the learning option in the
global mode:
wait-for-gsmp-syn
The following command has been added to disable the learning option in the
virtual router:
no
wait-for-gsmp-syn
.
The following command has been added to change the timer value:
gsmp-syn-timeout "value"
The following command has been added to change the timer to the default
value of 60 seconds:
no
gsmp-syn-timeout
In addition, the output of these two commands has been modified:
IPv6
Support for Configuring IPv6 HTTP Redirect URL from Profile Configuration
Mode
You can now provide initial provisioning and service selection for the
subscriber, by using the IPv6 HTTP redirect URL feature. You use the
ipv6 http
redirectUrl
command from the Profile Configuration mode to specify the URL
to which a subscriber’s initial Web browser session is redirected, as shown in
this example:
host1(config)#
profile guidEnt6
host1(config-profile) #
ipv6 http redirectUrl http://ispite.redirect.com
show configuration
show l2c
