Juniper JUNOSE 11.0.2 RELEASE NOTES, Release Note

Page: 54 / 118

JunosE 11.0.2 Release Notes
46 „
Known Problems and Limitations
MLD
„ MLDv2 proxy is not supported. [Defect ID 46038]
„ The E Series router MLDv2 proxy does not operate correctly in the presence of
MLDv1 queriers. [Defect ID 46039/46045]
Work-around: If an MLDv1 router is present on the network, configure version
1 with the ipv6 mld-proxy version command on that network interface.
(Version 2 is the default.)
„ The default value for the MLDv2 proxy unsolicited report interval timer should
be 1 second rather than 10 seconds (the value for v1). [Defect ID 46040]
„ The E Series router does not log a warning when it receives an MLDv1 query
but is not configured to use MLDv1 on the interface. [Defect ID 46046]
MLPPP
„ Failure to meet all of the following conditions for fragmented packets can result
in an incorrect operation during packet classification of the resulting
reassembled packet: [Defect ID 50111]
„ The initial fragment of a packet must either contain the entire MLPPP
packet or be greater than 128 bytes.
„ The fragment size of the peer must not be lower than 128 bytes.
„ The initial fragment of a packet must be larger than subsequent fragments
of that packet.
Mobile IP
„ The clear ip mobile binding nai @ realm command does not work. [Defect ID
178652]
Work-around: Use the following version of the command instead:
clear ip mobile binding nai user @ realm
„ The @ realm variable and the @ keyword alone do not work for the show ip
mobile binding command. [Defect ID 178653]
Work-around : You can use the user @ realm syntax instead to display the
binding for a specific user, as in this example:
host1# show ip mobile binding nai xyz@example.com
Alternatively, you can display the entire Mobile IP binding table by issuing the
show ip mobile binding command without additional options.
„ The setup rate for Mobile IP client sessions decreases when you repeatedly
bring a large number of sessions down and back up. [Defect ID 178760]