Known Behavior
33
Release 11.0.2
An error message regarding the qos-parameter instance
QosParameterDefinition is erroneously generated on an ERX1440 router when
it is configured for L2C and QoS RAM and receives TLV 144 (DSL Type). The
parameter instantiation actually functions properly. [Defect ID 80620]
On the E120 and E320 routers, you cannot attach QoS profiles to L2TP tunnels
by means of the CLI because the CLI does not pass the router ID to QoS.
[Defect ID 81516]
PPP sessions may be dropped if you change the shaping rate in a QoS profile
that affects thousands of circuits while QoS traffic affected by the profile is
being forwarded. [Defect ID 82950]
Work-around
: Do not change the shaping rate in a QoS profile that affects
thousands of circuits while QoS traffic is using the profile.
Egress traffic may be dropped on OC12/STM4 ATM interfaces if you have
shaped the port rate to more than 542 Mbps. [Defect ID 83785]
Work-around
: Do not exceed a shaped port rate of 542 Mbps.
Incorrect output is sent to the CLI the first time you enter Global Configuration
mode or issue the
show subscribers
command after viewing the VLAN
subinterface over which a subscriber is connected. [Defect ID 84507]
RADIUS
JunosE Software provides extended commands for configuring the formats of
the RADIUS NAS-Port attribute (attribute 5) and the RADIUS Calling-Station-ID
attribute (attribute 31) when the physical port value is greater than 7.
When the physical port value is greater than 7:
An incorrectly configured NAS-Port attribute format results if you use either
the
radius nas-port-format 0ssssppp
or
radius nas-port-format ssss0ppp
command.
An incorrectly configured Calling-Station-ID attribute results if you use
either the
radius calling-station-format fixed-format
command or the
radius calling-station-format fixed-format-adapter-embedded
command.
Work-around
: Use the following commands on routers that have line modules
with more than 7 physical ports:
To configure the NAS-Port attribute format, use the
radius nas-port-format
extended [ atm | ethernet ]
command.
To configure the Calling-Station-ID attribute format, use the
radius
calling-station-format fixed-format-adapter-new-field
command.
