Juniper CTP151 Platform, Hardware Manual, Page: 84 / 104

• Static routes added to the default interface, if any.
• Date and time GMT (more precisely, UTC)—Enter these separately in digits for the month, day, hour,
and minutes in Coordinated Universal Time (UTC), or accept the internal settings.
The device goes into startup mode.
For example:
***** First boot of this flash. Setting up basic system configuration. *****
*********** Setting up the root password ************
Changing root's password!
Changing password for user root.
New password:
Retype new password:
BAD PASSWORD: it is too short
passwd: all authentication tokens updated successfully.
Backing up /etc to nonvolatile storage..
************** Setting up the network ***************
Configure supported protocols:
0) IPv4 Only
1) IPv6 Only
2) IPv4 & IPv6
Please select your option (rtn for 0):
There are 2 ethernet devices available for use. The default device
is the device through which the default gateway can be accessed.
Ctp circuits can run over any ethernet device, default or not.
A default device must be configured, other devices may be configured
and enabled, or disabled. Here is a list to the available devices
and their descriptions:
eth0: 10/100/1000 Copper (labeled 0 on processor card)
eth1: 10/100/1000 Copper (labeled 1 on processor card)
eth2: 10/100/1000 Copper (labeled 2 on processor card)
eth3: 10/100/1000 Copper (labeled 3 on processor card)
eth4: 10/100/1000 Copper (labeled MGMT on processor card)
What device would you like to make the IPV4 default device? (rtn for eth0):
OK, eth0 (10/100/1000 Copper (labeled 0 on processor card)) will be configured as
IPV4 default device.
78