Jungheinrich EZS 350 XL, Operating Instructions Manual

Page: 99 / 125

11
.1
4
E
N
98
6.5 Restoring the truck to service after maintenance and repairs
Procedure
• Thoroughly clean the truck.
• Lubricate the truck according to the lubrication schedule, (see "Lubrication
Schedule" on page 92).
• Clean the battery, grease the terminals and connect the battery.
• Charge the battery, (see "Charging the battery" on page 33).
• Check the transmission oil for condensation water and replace if necessary.
• Check the hydraulic oil for condensation water and replace if necessary.
Z
The manufacturer's customer service department is specially trained to carry out
these operations.
WARNING!
Faulty brakes can cause accidents
As soon as the truck has been started, test the brakes several times.
 Report any defects immediately to your supervisor.

Tag out and decommission a faulty lift truck.
 Only return the truck to service when you have identified and rectified the fault.
• Start up the truck, (see "Starting up the truck" on page 44).
Z
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the controls by
applying them repeatedly.
11
.1
4
E
N
98
6.5 Restoring the truck to service after maintenance and repairs
Procedure
• Thoroughly clean the truck.
• Lubricate the truck according to the lubrication schedule, (see "Lubrication
Schedule" on page 92).
• Clean the battery, grease the terminals and connect the battery.
• Charge the battery, (see "Charging the battery" on page 33).
• Check the transmission oil for condensation water and replace if necessary.
• Check the hydraulic oil for condensation water and replace if necessary.
Z
The manufacturer's customer service department is specially trained to carry out
these operations.
WARNING!
Faulty brakes can cause accidents
As soon as the truck has been started, test the brakes several times.
 Report any defects immediately to your supervisor.

Tag out and decommission a faulty lift truck.
 Only return the truck to service when you have identified and rectified the fault.
• Start up the truck, (see "Starting up the truck" on page 44).
Z
If there are switching problems in the electrical system, apply contact spray to the
exposed contacts and remove any oxide layers on the contacts of the controls by
applying them repeatedly.