Jungheinrich EZS 350 XL, Operating Instructions Manual

Page: 67 / 125

11
.1
4
E
N
66
Setting the travel program configuration to a code
Procedure
• Press the O key (63).
• Enter the master code.
• Enter the three-digit parameter number 024.
• Confirm with the SET key (64).
• Enter the code to be changed and confirm with SET.
• Enter the configuration (4 digit) and confirm with SET.
• Enter the configuration (4 digit) again and confirm with SET.
• Repeat the procedure for other codes.
• Then press the O key.
The travel programs are assigned to the codes
Keypad event messages
The LED (65) flashes red to indicate the following events:
– New master code is already in use.
– New code is already the master code
– Code to be changed does not exist
– Attempt to change the code to one that already exists.
– Attempt to delete a code that does not exist
– Code memory full.
11
.1
4
E
N
66
Setting the travel program configuration to a code
Procedure
• Press the O key (63).
• Enter the master code.
• Enter the three-digit parameter number 024.
• Confirm with the SET key (64).
• Enter the code to be changed and confirm with SET.
• Enter the configuration (4 digit) and confirm with SET.
• Enter the configuration (4 digit) again and confirm with SET.
• Repeat the procedure for other codes.
• Then press the O key.
The travel programs are assigned to the codes
Keypad event messages
The LED (65) flashes red to indicate the following events:
– New master code is already in use.
– New code is already the master code
– Code to be changed does not exist
– Attempt to change the code to one that already exists.
– Attempt to delete a code that does not exist
– Code memory full.