Jungheinrich ETX ac 125, Operating Instructions Manual

Page: 69 / 89

501
1
838
6 GB
E 40
6 Monitoring function and safety devices
6.1 Emergency stop facility
When the automatic emergency stop facility is triggered (e. g. when guidance is lost
or the electrical steering fails) the truck is decelerated to standstill. Before bringing the
truck into service again the cause for the error (error code in display) must be
determined and, depending on the cause, qualified maintenance personnel must
eliminate the failure.
6.2 Drive cut-off with override (
o
)
If one of the criteria for drive cut-off is fulfilled the truck is decelerated to standstill.
After that the continuation of travel is possible at inching speed by pushing the
override button continuously.
A
The pushbutton for drive cut-off is located in the control panel.
6.3 Lift cut-off with override (
o
)
If required by the local conditions, an automatic lift cut-off, which is triggered at a
certain lifting height, can be built into the truck for safety reasons.
f
Overriding the lift cut-off requires special attention of the driver, in order to recognise
obstacles when the mast is extended.
– By continuously pushing button “Override lift cut-off” the lift cut-off is switched off.
– The indicator “Lift cut-off OFF” illuminates.
A
When lowering below the lift cut-off height the lift cut-off is activated again.
A
The pushbutton for lift cut-off is located in the control panel.
501
1
838
6 GB
E 40
6 Monitoring function and safety devices
6.1 Emergency stop facility
When the automatic emergency stop facility is triggered (e. g. when guidance is lost
or the electrical steering fails) the truck is decelerated to standstill. Before bringing the
truck into service again the cause for the error (error code in display) must be
determined and, depending on the cause, qualified maintenance personnel must
eliminate the failure.
6.2 Drive cut-off with override (
o
)
If one of the criteria for drive cut-off is fulfilled the truck is decelerated to standstill.
After that the continuation of travel is possible at inching speed by pushing the
override button continuously.
A
The pushbutton for drive cut-off is located in the control panel.
6.3 Lift cut-off with override (
o
)
If required by the local conditions, an automatic lift cut-off, which is triggered at a
certain lifting height, can be built into the truck for safety reasons.
f
Overriding the lift cut-off requires special attention of the driver, in order to recognise
obstacles when the mast is extended.
– By continuously pushing button “Override lift cut-off” the lift cut-off is switched off.
– The indicator “Lift cut-off OFF” illuminates.
A
When lowering below the lift cut-off height the lift cut-off is activated again.
A
The pushbutton for lift cut-off is located in the control panel.