JUMO TYA 202, Operating Manual, Page: 62 / 108

5 Configuration
60 2011-07-01/00561073 [SCR Power Controller TYA202]
5.1.7 Binary output
This parameter is used to specify the control direction of the binary output. It is con-
trolled by the multi-input interference signal.
v
Chapter 8.1 „Binary signal for collective fault“
h
Use the key to change to the Config level
➔
Binary output
Value/settings Description
Control direction,
binary output N/C contact No fault message pending:
14 and 15 pole and N/C contact closed or
13 and 15 optocoupler, collector-emitter loop high-impedance
Fault message pending:
13 and 15 pole and N/O contact closed or
13 and 15 optocoupler, collector-emitter loop low-impedance
N/O contact No fault message pending:
13 and 15 pole and N/O contact closed or
13 and 15 optocoupler, collector-emitter loop low-impedance
Fault message pending:
14 and 15 pole and N/C contact closed or
13 and 15 optocoupler, collector-emitter loop high-impedance
k/ bold = factory setting
13
14
15
E
S
C
Ö
P
Optocoupler
Relay
13
14
15
E
S
Optocoupler Relay
C
Ö
P
13
14
15
E
S
Optocoupler
Relay
C
Ö
P
13
14
15
E
S
C
Ö
P
Optocoupler
Relay