JUMO TYA 202, Operating Manual, Page: 54 / 108

5 Configuration
52 2011-07-01/00561073 [SCR Power Controller TYA202]
Resistance limita-
tion Note: Resistance limitation is only possible for controllers
with current and voltage measurement in which the
cas-
cade control P (code 001 in the
order code
) is integrated.
no No resistance limitation
yes The load resistance is monitored to ensure that the set resis-
tance limit is not exceeded.
In phase angle control mode, limitation is made via the phase
angle a.
In burst-firing mode, limitation is made via the ON/OFF ratio of
the sine waves.
v
Chapter 6.6 „Resistance limitation (R control)“
Resistance limit
value 0...999.99

If the load resistance exceeds this value, it is limited by phase
angle control or limitation of the switched sine waves.
Dual energy man-
agement switched off This parameter only appears for the following settings:
Cycle time: Fixed (500ms),
v
Chapter 5.1.2 „Power controller“
➔
Cycle time
Operating mode: Burst-firing operation
This allows 2 devices
1
to be set in such a way that they do not
consume energy from the power supply at the same time for
small output levels.
This avoids current peaks.
v
Chapter 6.4 „Dual energy management“
Device1
Device2
1. The Master/Slave connection, type 70.9062, is treated as "one“ device.
Value/settings Description
k/ bold = factory setting