JUMO DICON touch, Operating Manual, Page: 41 / 196

41
5 Operation
5.5.2 Program controller
Ö Chapter 2.1 "Order details", Page 13
Default setting
There are no programs available. The following options are available for creating a program:
Entering setpoint curves on the device
Ö Chapter 8.1.1 "On the device", Page 49
Entering setpoint curves using the setup program
Ö Chapter 8.1.2 "About the setup program", Page 50
Start, Stop
The black arrow starts an available program. A prompt appears asking which program should
be started and the programmed setpoint curves then run in sync for both control channels. The
symbol for automatic operation appears in the center. Touching the black rectangle stops the
program, and the statuses prior to the program starting are adopted again.
Pause
Pauses the time base of a program that is running, whereby the current setpoint values and the
statuses of the operating contacts are maintained. Touching the pause button again resumes
program operation at the same point.
Next section, previous section
The program that is running jumps to the next or previous section.
Temporary change
Allow one-time changes to the setpoint values for a program without storing it permanently in
the program table. When you next run the program, the original setpoint values will be reacti-
vated.
NOTE!
This screen is not available per default and only appears if the extra code for the program
controller has been enabled and configured.