Julabo MAGIO MS, Original Operating Manual, Page: 78 / 108

Operation
78
2. From the submenu <Use programmer>/<Programmer> call up the
menu option
<Manage profile>
.
3. Select a temperature control profile.
4. Press the
<Save> button.
5. Acknowledge the confirmation prompt.

The temperature control profile will be deleted. Once all steps are removed,
the [Add step] softkey remains in the deleted profile.
8.9.6 Profile series setup
The submenu <Activate programmer> is used to set up the sequence of a
profile series. This defines the start time, the number of runs, the cycle and the
behavior of the device at the end of the profile series.
 The device is switched on.
1. Call up the
<Main menu>
.
2. Call up the submenu <Use programmer> then the menu option
<Activate programmer>
.
3. Scroll down the menu page and select the sequence cycle with the [Series
type]
button.
 In addition to daily or weekly, individual weekdays can also be selected.
4. Use the
[Use end date]
button to select if the profile series should be
ended on a certain date.
5. If necessary, enter the desired end date using the
[End date]
button.

If no end date is used, the profile series will run until it is ended manually.

The profile series is set up. If the programmer is activated, the profile series
starts immediately or at the specified start time and runs through the
selected profile according to the defined settings. Then the programmer will
repeat the profile according to the set series type. After the profile series
has been completed, the device switches to the defined final state. An
ongoing profile series can be ended manually at any time.