– 81 –
(2) Checking the contour of a sewing pattern
1) Press
key to make the READY LED
light up.
2) Select the "INTERMEDIATE PRESSER"
with
key.
3) Lower the work clamp feet with the foot
switch.
The sewing machine does not
start even when the foot switch is
depressed under this mode.
4) Press
key in the state that the work
clamp feet are lowered.
The work clamp feet do not go
up even when the foot switch is
detached.
5) Confirm the contour of the pattern with
key or
key.
6) The work clamp feet will go up when
key
is pressed.
WARNING :
Make sure without fail of the contour of the sewing pattern after selection of the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle will interfere with the work
clamp feet during sewing, causing dangerous troubles including needle breakage.
8
Finish of setting
1) Press the
key.
2) After the work clamp feet have moved and gone
up, the sewing LED lights up, and the sewing is
ready.
1. When the data is changed, press
to confirm the change.
2. When selecting the items of the height of the intermediate presser and the bobbin
winder, the machine cannot move to the sewing state. Select other items.
3. If
key is pressed, you can make sure of the respective setting items again.
However, the items can not be changed in the state that the SEWING LED is lit up.
4. When
key is pressed, the READY LED goes off. Set values of the respective
items can be changed.
5. Thread tension can be changed even when the sewing LED lights up.
6. Use the machine after confirming the pattern No. When
key is pressed
while pattern No. is indicated "0" (state at the time of delivery), error display E-10
appears. At this time, re-set the pattern No.
7. Change of the height of the intermediate presser and the bobbin winder fail to
work immediately after turning ON the power. Use the machine after pressing
READY key
and performing the origin retrieval.
h
h
d
e
