JRC JAN-7202, Instruction Manual

Page: 219 / 332

9-11 Section 9 Maintenance & Inspection
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
19
21
23
24
24
26
27
[2] [Sensor Selection]
Enables selection of a sensor source.
Setting item Description of Setting Setting value
Position
Select a Primary Position sensor source from the
combo box.
GPS x, DR
("x" indicates the unit
number)
Heading Select a heading sensor source from the combo box.
*The source that can be selected varies depending on
the installation.
*When GyroSW is enabled, only Gyro and MAN can be
selected.
When the sensor source is set to [Manual], the heading
value can also be input in the input box.
Heading value input range: 0.0-359.9
°
MAN, Gyro x
("x" indicates the unit
number)
STW (Speed
Through Water) Select a Speed Through Water sensor source from the
combo box.
*The sources that can be selected vary according to the
installation.
* When 1AX is installed for Log, Log cannot be selected
from the sensor source.
When the Gyro Compass system that is used has the
automatic switching function, the sensor source display
is switched automatically according to the switching
condition.
When the sensor source is set to [MAN], the ship’s
heading value can also be input in the input box.
Ship’s heading value input range: -99.9-99.9kn
MAN, Gyro X, MAG,
G/C
("x" indicates the unit
number)
COG/SOG
(Course Over the
Ground/Speed
Over the Ground)
Select Course Over the Ground/Speed Over the
Ground sensor source from the combo box.
*The source that can be selected varies depending on
the installation.
When GPS is selected for Position, the same GPS is
selected automatically.
Log x, GPS
("x" indicates the unit
number)
Time (Time
correction) Select a sensor source to be used for time correction of
this equipment from the combo box.
*The source that can be selected varies depending on
the installation.
GPS, Ship Clock
Depth (water
depth) Select a water depth sensor source from the combo
box.
*The selectable sources vary depending on the
installation. When FURUNO is selected in [Device
Installation] - [Echo Sounder 1], it is fixed to AUTO.
FWD, AFT, MID,
AUTO
*1
SOG(Docking) Select a sensor source of the Speed Over the Ground
(Docking) from the combo box.
*The source that can be selected varies depending on
the installation.
Log x, GPS
("x" indicates the unit
number)
Navigational Data Select a source (sensor) from which route monitoring
information is acquired.
*The source that can be selected varies depending on
the installation.
* Cannot be selected when there is equipment that is
performing Auto Sailing and the "Switch to equipment
for Autosailing" check box is selected.
ECDIS x, MFD x
("x" indicates the unit
number)