Joyello JL-1048 SECURFIX BEEP, User Manual

Page: 28 / 68

28
GB
To release the seat from the base, press and hold the seat locking button whilst simultaneously
pushing the release button. Then pull the seat up as shown in the picture.
INSTALLATION FOR GROUP 0+ (0-13 KG) / (rear-facing)
15. Installing the safety group 0+
14. Installation of installing the shell
Put the shells on the base,heard “CLICK”,and check the color of the knob
place, whether it is green.
13. Shell unlocked instructions
Press the insurance device and push the button as the direction of arrow.
At the same time, another hand takes shell upwards. Shell will be separated
from the base.
11 12
1
2
3
推
PUSH
OK!
C2
C 4
C 6
C 6
C 5
It is suitable for the weight 0-13kg,given to children under the age of about 1.
STEP 1: Flat on the ISOFIX base on the car seat,the ISOFIX base connected with the
connection device on the car(C1).
Combine the car seat with isofix base(C2,C3,C4).
NOTE: Pull outward ISOFIX base to ensure that both sides have been locked.
STEP 2:
STEP 3: There are 3 recline position available. Adjust the seat to suitable position(C5).
STEP 4:
Push in the direction of car back seat,make sure that the front of the baby
seat is firmly pressed against the backrest of car seat (C6).
STEP 5: By adjusting the length of the leg to make it
touch the ground of car.
Leg not hanging in the air or other items can be
used to support.At thesame time to ensure that the leg
is no higher than the safety seat.Check whether leg
shows green(C7).
NOTE:
C3
OK!
C1
7
Place the seat base on the vehicle’s seat and extend the ISOFIX connector arms (fig.C1). Ensure that
the base is correctly connected on both sides.
Insert the seat into the base (fig.C2/C3/C4).
Recline the child seat into the desired position (3 available positions - Fig. C5).
Press the base against the vehicle’s seat to bring the child seat as close as possible to the backrest
of the vehicle’s seat (fig.C6).
Adjust the height of the support leg so it rests solidly on the floor of the vehicle. To be sure that
the support leg is correctly placed on the floor of the vehicle, ensure that the green indicator is
showing (fig.C7).