Installing the module
This section describes how to mount the enclosure, install the battery, and wire the system.
The enclosure has three breakaway tabs that you can use for wiring access during installation.
There are also two slots for the battery strap to pass through. For more information, see the
highlighted areas in Figure 1.
Note:
Remove the breakaway tabs only if required.
Note:
Install the module in the protected area of the protected premises. The wiring methods
shall be in accordance with ULC-S302, NFPA72, the National Electrical Code, ANSI/NFPA 70,
the Standard for Installation and Classification of Burglar and Holdup Alarm Systems, UL 681,
and the Standard for Central Station Alarm Services, UL 827. This module should be installed
in accordance with Chapter 29 of the National Fire Alarm and Signaling Code, ANSI/NFPA 72,
(National Fire Protection Association, Batterymarch Park, Quincy, MA 02269).
Figure 1: Breakaway tabs and battery strap slots
Callout
Description
1
Breakaway tabs
2
Slots for the battery strap
Note:
Securing the battery in the enclosure with the battery strap is optional.
The battery strap is sold separately.
3
Wall tamper screw
9
PG8HRDW8 and PG9HRDW8 IQ Hardwire PowerG Wired to Wireless Converter Installation Manual
