119
E8
Valve position was not entered in electronic unit (error
code only in optimization or minimization programs).
•
Position valve exactly perpendicular to and above
main shaft and press the OP key.
E9
Optimization/minimization was carried out incorrectly.
1. Wheel was not exactly centered on clamping means
during
every run.
2. Tire was eccentric relative to rim for at least one
time.
3. Valve position was incorrectly indexed for at least
onetime,
and entered incorrectly.
4. Wrong mark (single or double mark) was used for
reference
when readjusting the tire.
5. Wheel got out of place on the clamping means during
the
measuring run (sudden start or stop, or the like).
6. Wrong wheel dimensions were entered.
•
Repeat the optimization procedure.
E15
Corrective term of readjustment is out of range.
During readjustment values were determined which
exceed, or fall short of, the given adjustment value.
The error code is a warning only, press the C key to
transfer the corrective terms into the permanent
memory.
•
Use clamping means supplied with the machine,
or have basic calibration carried out (service).
E16
During the first readjustment run by the operator the
calibration
weight was fitted by mistake.
•
Unscrew the calibration weight and start the
measuring run again.
E17
Wheel slips on clamping means.
The clamping nut is not well tightened, the main shaft
accelerates too quickly. The machine will stop.
•
Firmly tighten the clamping nut, or in special cases
press
the START key a little bit longer.
E83
During a measuring run the measured data have been
made useless under the effect of outside pulses (e. g.
vibrations) and measurement was interrupted.
•
Repeat the measuring run.
