54
5.3.3.6-2
5.3.3.6-3
5.3.3.6-2c
5.3.3.6-2a
5.3.3.6-2b
•
To determine the gauge application position AP1,
pull the gauge arm for distance and rim diameter
out of the cabinet, apply the gauge head on the
rim in the center of the intended weight fitting
position as shown in Fig. 5.3.3.6-2a and 5.3.3.6-
2c and hold in that position.
An audible signal is given when the application position
AP1 has been stored.
•
Approach the gauge head to application position
AP2 and hold in that position (Fig. 5.3.3.6-2b and
5.3.3.6-2c).
An audible signal is given when the application position
AP2 has been stored.
•
Return the gauge arm for distance and rim diameter
to its home position.
The rim dimensions are read out on the monitor
between the relative arrows in the display fields as soon
as the gauge arm is moved into its home position after
the measurement.
•
Start the measuring run.
Fitting of balance weights
The weight for AP1 is a balance clip and is attached
perpendicular to the main shaft after indexing the wheel,
as in balancing mode nor. The gauge arm stays in its
home position.
The adhesive weight for AP2 is fitted as described
below:
•
Select an adhesive weight of the indicated size and
ad-just it to the wheel radius by bending.
•
If necessary, index the wheel precisely into the
correction position for the left plane. When the
correction position is reached, the two arrows on
the screen light up green.
•
Press the pedal of the main shaft lock to hold the
wheel in this position.
•
Clean the fitting position before attaching the
adhesive weights.
•
Raise the gauge arm (1, Fig. 5.3.3.6-3) and pull the
holding ring of the gauge head (2, Fig. 5.3.3.6-3)
inwards.
•
Insert the adhesive weight (3, Fig. 5.3.3.6-3) into
the head with the protective foil facing upwards
symmetrically relative to the arrow (4, Fig. 5.3.3.6-
3).
•
Press the adhesive weight firmly against the head
and remove the protective foil from the weight.
•
Pull the gauge arm towards application position AP2.
The display shows the position of the gauge arm for
distance and diameter. If the application position
AP2has been reached, a little red arrow becomes green
and an audible signal is given.
•
Press the pedal of the main shaft lock to hold the
wheel in this position.
