39
A key is jammed.
•
Find and release jammed key.
If the error cannot be remedied, call service.
H82
The self-test was disturbed (e.g. by rotating the wheel).
The message is displayed for 3 seconds, after which
the measurement is repeated (max. 10 times), or
aborted by pressing the STOP key or the ESC key.
E3
Gauge arm for distance and rim diameter is not in home
position.
•
Move gauge arm to its home position. Press the
STOP key or the ESC key.
E92
During the second attempt the gauge arm for distance
and rim diameter was still not in the home position.
The gauge arm is rendered inoperative.
•
Wait 3 seconds, or press the STOP key or the ESC
key to continue.
E145
The contents of both permanent memories are different,
but both contain valid data.
Fatal error codes
The self-test program has detected an error and
displays a alphanumeric code consisting of six digits
and/or letters.
C10 800
Line voltage under 170 V. Balancing is feasible if the
motor can drive the main shaft to the measuring speed.
Wheel data may be lost.
•
Bring the line voltage to within a range of 200 - 230
–240 Volts with an input transformer (ref. 6705 902).
C10 801
Line voltage over 265 V. Damage to the electronic unit
of the machine is likely!
•
Bring the line voltage to within a range of 200 - 230
–240 Volts with an input transformer (ref. 6705 902).
C10 804
Line voltage over 275 V. Damage to the electronic unit
of the machine is likely! Turn off mains switch. Any
damage resulting from repeated occurrence of this error
code is not covered by the guarantee.
•
Bring the line voltage to within a range of 200 - 230
–240 Volts with an input transformer (ref. 6705 902).
