JMP FOX 4000 H, Operation Instructions Manual

Page: 17 / 62

15
7. Safety regulations
Observe applicable, statutory and valid accident prevention regulations when handling lifts.
Observance of the following regulations is indicated in particular:
-
The total weight of the supported vehicle should not exceed 4000 kg, whereby the maximum load distribu
tionis 3:1 in the drive direction or contrary to the drive direction.
-
Observe the operating instructions when operating the lift.
-
The lift must be lowered completely prior to driving on the vehicle, and driving on should only be realised in
the intended direction.
-
In the case of vehicles with low ground clearance or special fittings, check whether damage could occur
prior to driving onto the lift and raising the vehicle.
-
Only persons of 18 years of age or older who have been instructed in operation of the lift (observe the han
dover protocol) and have verified their employment for this purpose with regard to the employer are per
mitted to operate the lift independently. They must be expressly commissioned by the employer with ope
ration of the lift (excerpt BGR 500 (German trade association rules), see handover protocol).
-
Any displacement of the centre of gravity must be taken into consideration when removing heavy parts.
The vehicle must be appropriately secured against falling through suitable means (e.g. lashing straps, beams, etc.).
-
No persons should be in the working area during the raising or lowering procedure.
-
The conveyance of persons with the lift is prohibited.
-
Climbing up on the lift is prohibited.
-
The lift must be inspected by an expert following modification of the construction and repairs to supporting parts.
-
Interventions for the purpose of repairing and maintaining the lift may only be undertaken by skilled personnel
if the main switch is deactivated.
-
The complete raising and lowering procedure should be observed at all times.
-
Personnel should move immediately to the safety zone outside the lift in the event of the vehicle moving
unintentionally on the platform.
-
The vehicle should not be moved when the platform is raised and should be appropriately secured by actu
ating the parking brake. Always use the safety catch function of the lift.
-
Ensure when lowering the platform that feet are kept out of the working area where they could be entrapped.
-
No objects or persons should be under the vehicle or under the lift when lowering the lift.
-
When using an optional axle jack, ensure that feet are kept clear of the scissor mechanism.
-
Installation of the standard lift is prohibited in potentially explosive premises and damp rooms (e.g.
washing bays).