JMP FOX 4000 H, Operation Instructions Manual

Page: 19 / 62

17
8.1. Raising the vehicle
-
Drive the vehicle aligned centrally in a transverse direction into the lift.
-
Secure the vehicle against rolling. Pull the parking brake and engage a gear.
-
Pivot in the support arms and apply the adjustable pick-up plates at the points provided by the vehicle manu-
facturer. Rotate the pick-up plates uniformly upwards if necessary.
⚠
Caution: The load must be supported centrally on the pick-up plate!
-
Check that no objects or persons are in the hazardous zone of the lift.
-
Activate the main switch.
-
Lift the vehicle free of ground contact. Press the “Up” button on the control element.
-
Interrupt the lifting procedure when the wheels are free of ground contact and check the pick-up plates again
to ensure they are providing safe support.
-
The support arm locking systems must be engaged. If not, the lift should be set down and the vehicle repositi-
oned again.
-
Raise the vehicle to the desired working height. Press the “Lock” button to secure the position with the safety
catch.
-
The position of the support arms under the support points should be checked again each time the vehicle is
set down and adjusted if necessary.
-
The complete lifting procedure should be observed at all times to ensure the vehicle roof does not touch the
cross support.
-
Check that no objects or persons are in the hazardous zone of the lift.
⚠
Caution: Ensure to pay attention to the secure seat of the vehicle on the tragtellern, otherwise
there is a risk of falling!

Caution: Care must be taken to ensure that the support arm locks are engaged after
picking up the vehicle!
8.2. Lowering the vehicle
-
Check that no objects or persons are in the hazardous zone of the lift.
-
Lower the vehicle to the desired working height or to the lowermost position by pressing the “Down” button.
The lift initially moves up slightly to relieve the catch. The lowering procedure then starts automatically.
-
The lowering procedure should be observed at all times.
-
Pivot the support arms outwards if the lift has reached the identifiable lowermost position. The vehicle can then
be driven out of the lift.