SECTION 5 - JLG CONTROL SYSTEM
5-18
31215079
5.4
CHASSIS TILT SENSOR INSTALLATION
NOTE:
Refer to Figure 5-5., Chassis Tilt Sensor Removal for
numbers in parenthesis.
1. Disconnect the batteries.
2. Open the ground control box to gain access to the
tilt sensor assembly.
3. Disconnect the tilt sensor wiring connector (SN3)
from the (X03) harness connector on the side of the
box.
4. Remove the four screws (3), lock washers (4), standoff
insulators (5), and washers (6) to remove the tilt sen-
sor (1) and sensor mount (2) from the ground control
box.
5. The tilt sensor (1) can be removed from the sensor
mount (2) by removing the two screws (7) and wash-
ers (6).
NOTE:
Follow the above procedures in reverse order when
installing the chassis tilt sensor assembly. Torque
screws (7) to 106 in. lbs (12 Nm).
NOTE:
After installing, be sure to calibrate the chassis tilt
sensor (refer Section 5 for calibration procedure.)
Chassis Tilt Sensor -
If this sensor is not wired correctly
or if you have the wrong part number you will get CAN-
BUS FAILURE - CHASSIS TILT SENSOR
1. Ground Control Box
2. Tilt Sensor Assembly
Figure 5-4. Chassis Tilt Sensor Location
2
1. Chassis Tilt Sensor
2. Sensor Mount
3. Mount Screws
4. Lockwashers
5. Stand-off Insulators
6. Washers
7. Sensor Screws
8. (SN3) (X03) Harness
Connector
Figure 5-5. Chassis Tilt Sensor Removal
Table 5-1. Tilt Sensor Harness (SN3)
Wire Color
Function
Connector Pin
White
VCC
1
Yellow
GND
2
Green
CANH
3
Brown
CANL
4
8
Go
to
Discount-Equipment.com
to
order
your
parts
