JK2830 Operation Manual Contents
III
3.4.4 Delay time .....................................................................24
3.4.5 Output impedance ...........................................................24
3.4.6 Deviation test function .....................................................25
3.4.7 DC bias ..........................................................................26
<LIMIT TABLE> ....................................................................27
3.5.1 Swap parameter ..............................................................27
3.5.2 Limit modes of compare function .......................................28
3.5.3 Set nominal value of tolerance mode ..................................29
3.5.4 Comparator function ON/OFF ............................................29
3.5.5 Auxiliary bin ON/OFF .......................................................30
3.5.6 HIGH/LOW .....................................................................30
<CORRECTION> ...................................................................31
3.6.1 OPEN .............................................................................33
3.6.2 SHORT ...........................................................................34
3.6.3 LOAD .............................................................................35
3.6.4 Load correction test function .............................................37
3.6.5 Cable length selection ......................................................37
3.6.6 Single/ multi correction mode ...........................................37
3.6.7 Open/Short correction on <MEAS DISP> page .....................38
<LIST SETUP> .....................................................................39
Chapter 4 SYSTEM and FILE ..................................................................10
<SYSTEM> ..........................................................................10
4.1.1 SKIN .............................................................................10
4.1.2 LANGUAGE .....................................................................10
4.1.3 PASS ALARM ...................................................................11
4.1.4 FAIL ALARM ....................................................................11
4.1.5 KEY SOUND ....................................................................11
4.1.6 PASSWORD ....................................................................12
4.1.7 SAVE TYPE .....................................................................12
4.1.8 BUS MODE .....................................................................12
4.1.9 BAUD RATE ....................................................................13
4.1.10 DATE/TIME .....................................................................13
4.1.11 SYSTEM INFORMATION ....................................................13
4.1.12 FIRMWARE UPDATE .........................................................14
4.1.13 SYSTEM TEST .................................................................14
<FILE> ...............................................................................15
4.2.1 Setup file for single-group component (*.EST).....................15
4.2.2 U-disk manage performance .............................................16
4.2.3 Operation steps for file management ..................................16
Chapter 5 Execute LCR operation and some examples ..............................18
Correct connection of DUT ......................................................18