JK2830 Series Operation Manual Chapter 3 Introduction to [DISP]
40
◼
Sweep mode (
SWEEP MODE
)
◼
Sweep parameter setup (frequency
[Hz]
, level
[V]
, level
[I]
, bias
[V]
, bias
[I]
)
◼
Sweep test point setup (sweep point)
◼
Selection of limit parameter (
LMT
)
◼
High/low limit (
HIGH
,
LOW
)
3.7.1
MODE and FAIL MODE
Mode and Fail mode menu is the same as the mode on <List sweep display>
page.
3.7.2
Test parameter
Sweep parameters can be: frequency [Hz], level
[V]
, level
[I]
, bias
[V]
, bias
[I]
.
Operation steps for setting test parameter
1)
Move the cursor the table to perform the setup of each sweep parameter:
LEV[V]
and
BIAS[x]
; the following soft keys will be displayed.
◼
LEVEL [V]
◼
LEVEL [A]
◼
BIAS [V]
◼
BIAS [A]
2)
Press one of above soft keys to select the list sweep parameter.
3.7.3
Sweep parameter setup
Move the cursor to the table to perform the setup of each sweep parameter:
FREQ (HZ)
,
LMT
,
HIGH
and
LOW
. Use numeric keys on the front panel to input
the data of test frequency/level/bias and high/low limit used to compare, as well
as the selected primary/secondary use to compare. After setting, if some inputs
are unnecessary, you can execute the function of “
OFF
” in the soft key zone to
delete the corresponding value.
In the bottom of the
LMT
zone, parameter A indicates that the primary
parameters of the measurement result are use to compare with the high and low
limits of the table. Parameter B indicates that the secondary parameters of the
measurement result are used to compare with the high and low limits of the table.
“
---
“ means no compa
re.
