158
Field Name
Description
Active/Active Cluster: Both servers are acting as an
independent server and backup for each other. The register
information will be forwarded to backup node to speed up the
fail over timing. Once the active one is failed to service, it will
switch over to backup node.
Active/Standby Cluster: One of cluster server will become
active while another one is a backup server. The register
information will be forwarded to backup node to speed up the
fail over timing. Once the active one is failed to service, it will
switch over to backup node.
HA Member 1
The cluster member's host name which is get from uname ?
n. Please note that both server settings need the same
order. This cluster member will start and service HA Group 1
by default in Active/Active mode
HA Member 2
The cluster member's host name which is get from uname ?
n. Please note that both server settings need the same
order. This cluster member will start and service HA Group 2
by default in Active/Active mode.
HA Group 1
Resource Status
The status of High Available Group 1. It is required for both
AA and AS modes.
IPV4 VIP for WAN
Virtual IP V4 address for WAN interface.
IPV4 VIP for LAN
Virtual IPV4 address for LAN interface.
IPV6 VIP for WAN
Virtual IP V6 address for WAN interface. The IPV6 address
must be a global unicast addressed, not a link-local or site-
local address. IPV6 VIP for WAN is only available when 1
Ethernet leg mode is used (Attached LAN Interface is
disabled).
IPV6 VIP for LAN
Virtual IP V6 address for WAN interface. Virtual IP V6
address for WAN interface. The IPV6 address must be a
global unicast addressed, not a link-local or site-local
address. It could be use fc00:xxxx:xxx:xxx as the private IP V6
address. IPV6 VIP for LAN is only available when 2 Ethernet
legs mode is used (Attached LAN interface is enabled).
Service Controller
It is a internal status for HA resource status controlling.
Status
Resource status and which server is servicing now.
Failcount
If there is a problem to start the resource, HA will try to restart
it and add 1 for the Failcount. Normally, it will be 0.
HA Group 2
High Available Group 2. It is only required for AA mode.
Summary of Contents for UniPBX-2000
